Dell EMC PowerEdge R440 - Optional IDSDM or Vflash Module; Removing the Microsd Card

Figure 70. Installing the M.2 SSD module
1 module connector (2) 2 screws (2)
3 modules (2)
Next steps
1 Install the BOSS card.
NOTE
: Installing the BOSS card is similar to installing the expansion card riser.
2 Install the air shroud.
3 Follow the procedure listed in After working inside your system.
Optional IDSDM or vFlash module
The IDSDM or vFlash module combines the IDSDM or vFlash features into a single module.
NOTE
: The write-protect switch is on the IDSDM or vFlash module.
Removing the MicroSD card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Steps
1 Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate IDSDM/
vFlash module, see the System board jumpers and connectors section.
2 Hold the MicroSD card and remove it from the slot.
NOTE
: Temporarily label each MicroSD card with its corresponding slot number after removal.
112 Installing and removing system components