Figure 30. Removing a drive blank
Next step
1 Install a drive or a drive blank.
Related links
Installing a drive blank
Installing a drive blank
The procedure for installing 2.5 inch and 3.5 inch drive blanks is identical.
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 If installed, remove the front bezel.
CAUTION
: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Step
Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 31. Installing a drive blank
Next step
If removed, install the front bezel.
Installing and removing system components
75
To Next Page
Loading...
