Dell EMC PowerEdge R440 - Installing a Power Supply Unit

Figure 93. Removing a power supply unit
Next step
Install the PSU.
Related links
Installing a power supply unit
Installing a power supply unit
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 For systems that support redundant PSU, ensure that both the PSUs are of the same type and have the same maximum output
power.
NOTE
: The maximum output power (shown in watts) is listed on the PSU label.
Step
Slide the PSU into the system until the PSU is fully seated and the release latch snaps into place.
132
Installing and removing system components