Dell EMC PowerEdge R440 - Processor Specifications; Memory Specifications

System Maximum weight (with all drives/SSDs)
10 x 2.5 inch drive system 16.8 kg (37 lb)
Processor specications
The PowerEdge R440 system supports up to two Intel Xeon Processor Scalable Family processors.
PSU specications
The PowerEdge R440 system supports the following AC power supply units (PSU).
Table 16. PSU specications
PSU Class Heat dissipation
(maximum)
Frequency Voltage
550 W AC Platinum 2559 BTU/hr 50/60 Hz 100–240 V AC, autoranging
450 W AC Bronze 1871 BTU/hr 50/60 Hz 100–240 V AC, autoranging
NOTE: Heat dissipation is calculated using the PSU wattage rating.
NOTE: This system is also designed to connect to the IT power systems with a phase-to-phase voltage not exceeding 230 V.
System battery specications
The PowerEdge R440 system supports CR 2032 3.0-V lithium coin cell system battery.
Expansion bus specications
The PowerEdge R440 system supports PCI express (PCIe) generation three expansion cards, which must be installed on the system board
using expansion card risers. The R440 system supports three types of expansion card risers.
Table 17. Expansion card riser
congurations
Expansion card riser PCIe slots on the riser Processor connection Height Length Slot width
Riser 1A Slot 1 Processor 1 Low Prole Half Length x16
Slot 2 Processor 1 Low Prole Half Length x16
Riser 2A Slot 3 Processor 2 Low Prole Half Length x16
Riser 1B Slot 1 Processor 1 Low Prole Half Length x16
Riser 2B Slot 2 Processor 2 Full Height Three-fourth Length x16
Riser 1B Slot 1 Processor 1 Low Prole Half Length x16
Memory specications
The PowerEdge R440 system supports 16 DDR4 registered DIMM (RDIMMs) slots. Supported memory bus frequencies are 2666 MT/s,
2400 MT/s, 2133 MT/s, and 1866 MT/s.
Technical
specications 25