Dell EMC PowerEdge R440 - Removing the PERC Card from the Internal PERC Riser

Removing the PERC card from the internal PERC riser
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the Air shroud.
4 Remove the internal PERC riser.
Steps
1 Using a Phillips #2 screwdriver, remove the screw that secures the PERC card to the internal PERC riser.
2 Pull the PERC card out of the connector on the internal PERC riser.
Figure 53. Removing the PERC card from the internal PERC riser
Next steps
1 Install the PERC card into the internal PERC riser.
2 Replace the Air shroud.
3 Follow the procedure listed in After working inside your system.
Related links
Removing the internal PERC riser
Installing PERC card into the internal PERC riser
Installing and removing system components
95