Figure 21. Inside the system
1
left control panel cable cover 2 hard drive backplane
3 backplane expander board 4 cabling latch
5 air shroud 6 intrusion switch
7 power interposer board 8 internal expansion riser
9 low prole expansion riser 1 10 low prole expansion riser 2
11 processor blank 12 heat sink
13 air shroud 14 cooling fan blank
15 left control panel cable cover 16 information tag
Backplane cover
Removing the backplane cover
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the system cover.
Steps
1 Slide the backplane cover in the direction of the arrows marked on the backplane cover.
2 Lift the backplane cover away from the system.
66
Installing and removing system components
To Next Page
Loading...
