Dell EMC PowerEdge R440 - Storage Controller Specifications; Drive Specifications; Drives; Ports and Connectors Specifications

Table 18. Memory specications
Memory module sockets Memory capacity Minimum RAM Maximum RAM
Sixteen 288-pin
• 8 GB, 16 GB, 32 GB or 64 GB
DDR4 single rank, dual rank or
quad rank (RDIMMs)
• 4 GB with single processor
• 8 GB with dual processors
(minimum one memory module
per processor)
• Up to 256 GB with a single
processor
• Up to 384 GB with a dual
processor
Storage controller specications
The PowerEdge R440 system supports:
• Internal storage controller cards: PowerEdge RAID Controller (PERC) H330P, PERC H730P, PERC H740P, HBA330, and PERC 10.
• External storage controller cards: PERC H840 and 12Gbps SAS HBA.
Drive specications
Drives
The PowerEdge R440 system supports:
• Up to 4 x 3.5 inch drives with hard drive adapter, internal, hot swappable SAS, SATA, or Nearline SAS drives
• Up to 8 x 2.5 inch drives or 10 x 2.5 inch drives with hard drive adapter, internal, hot swappable SAS, SATA, or Nearline SAS drives
• Up to 4 x 3.5 inch drives or 8 x 2.5 inch drives or 10 x 2.5 inch drives with hard drive adapter, internal, hot swappable SATA SSDs
Ports and connectors specications
USB ports
The following table provides more information about the USB specications:
Table 19. USB
specications
Front panel Back panel Internal USB
• One USB 2.0-compliant port
• One iDRAC Direct (Micro-AB USB)
port
• Two USB 3.0-compliant port • One internal USB 3.0 port
NIC ports
The PowerEdge R440 system supports two Network Interface Controller (NIC) ports on the back panel, which have two 1 Gbps
conguration.
NOTE
: You can install up to ve PCIe add-on NIC cards.
26 Technical specications