NOTE: Ensure that you note the routing of the cables as you remove them from the system board.
Figure 26. Removing the cooling fan
2 Lift the fan out holding the blue touch point.
Next steps
1 Install the cooling fan.
2 Install the internal riser.
3 Connect the power cable to the system board.
4 Ensure the cables are routed correctly.
5 Install the air shroud.
6 Follow the procedure listed in After working inside your system.
Related links
Removing the air shroud
Removing the internal PERC riser
Installing cooling fan
Installing cooling fan
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
4 Remove the internal riser.
5 Remove the power cable.
Installing and removing system components
71
To Next Page
Loading...
