Dell EMC PowerEdge R440 - Installing a Non-Redundant Cabled AC Power Supply Unit

Figure 95. Removing non-redundant cabled AC PSU
Next step
1 Installing a non-redundant cabled AC power supply.
Related links
Removing the air shroud
Removing an expansion card riser
Installing a non-redundant cabled AC power supply unit
Installing a non-redundant cabled AC power supply unit
Prerequisite
1 Follow the safety guidelines listed in Safety instructions.
Steps
1 Unpack the new power supply unit (PSU).
2 Slide the new PSU into the PSU cage until the PSU is fully seated.
3 Using a Phillips #2 screwdriver, replace the screw to secure the PSU to the system.
Figure 96. Installing a non-redundant cabled AC PSU
Next steps
1 Connect the PSU cables to the connectors on the system board.
134
Installing and removing system components