Figure 72. Installing optional IDSDM/vFlash card
Next steps
1 Install the MicroSD cards.
NOTE
: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
2 Follow the procedure listed in After working inside your system.
LOM riser card
The LOM riser card is a small, removable mezzanine card, which provides the exibility of selecting dierent network connectivity options.
Removing the LOM riser card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If installed, remove the risers.
Steps
1 Using a Phillips #2 screwdriver, loosen the screws that secure the LOM riser card to the system board.
2 Release the two blue side plastic snaps holding the LOM riser card.
3 Hold the LOM riser card by the edges on either side, and lift to remove it from the connector on the system board.
4 Slide the LOM riser card towards the front of the system until the Ethernet connectors or the Small form-factor pluggable (SFP) are
clear of the slot in the back of the system.
Installing and removing system components
115
To Next Page
Loading...
