Dell EMC PowerEdge R440 - Installing the Air Shroud

Figure 24. Removing the air shroud
Next steps
1 If applicable, install the air shroud.
2 Follow the procedure listed in After working inside your system.
Related links
Removing an expansion card riser
Installing the air shroud
Installing the air shroud
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 If applicable, route the cables inside the system along the system wall and secure the cables by using the cable latch.
Steps
1 Align the tabs on the air shroud with the slots on the system.
2 Lower the air shroud into the system until it is rmly seated.
When rmly seated, the memory socket numbers marked on the air shroud align with the respective memory sockets.
Installing and removing system components
69