Steps
1 Route the control panel cable through the system.
2 Align the right control panel with the control panel slot on the system and place the assembly in the slot on the system.
3 Connect the control panel cable to the connector on the system board and lower the cable latch to secure the cable in place.
4 Using a Phillips #1 screwdriver, install the screw that secures the control panel to the system.
Figure 104. Installing the right control panel
5 Using a Phillips #1 screwdriver, install the screws that secure the cable cover to the system.
Figure 105. Installing the cable cover
Next steps
1 Install the internal PERC riser.
2 Follow the procedure listed in After working inside your system.
140
Installing and removing system components
To Next Page
Loading...
