EasyManua.ls Logo

Dell EMC PowerEdge R440 - Page 15

Dell EMC PowerEdge R440
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table 8. 2 X 2.5 inch drive system with 1 PCIe expansion slot
Item Ports, panels, or slots Icon Description
1 Serial port Use the serial port to connect a serial device to the system. For more
information about the supported serial port, see the Technical
specications section.
2 iDRAC9 Enterprise port
Use the iDRAC9 dedicated network port to securely access the
embedded iDRAC on a separate management network, see the
Integrated Dell Remote Access Controller User's Guide at Dell.com/
idracmanuals.
3 Ethernet ports (2) Use the Ethernet ports to connect Local Area Networks (LANs) to the
system. For more information about the supported Ethernet ports, see
the Technical specications section.
4 Full height riser slot N/A Use the card slots to connect full-height PCIe expansion cards on full
height riser.
5 Power supply unit (PSU) N/A For more information about the PSU congurations, see the Technical
specications section.
6 LOM riser ports (2)
7 USB 3.0 port (2) Use the USB 3.0 port to connect USB devices to the system. These
ports are 4-pin, USB 3.0-compliant.
8 VGA port Use the VGA port to connect a display to the system. For more
information about the supported VGA port, see the Technical
specications section.
9 CMA power port N/A The Cable Management Arm (CMA) power port enables you to connect
to the CMA.
10 System identication button Press the system ID button:
To locate a particular system within a rack.
To turn the system ID on or o.
To reset iDRAC, press and hold the button for more than 15 seconds.
NOTE:
To reset iDRAC using system ID, ensure that the system ID
button is enabled in the iDRAC setup.
If the system stops responding during POST, press and hold
the system ID button (for more than ve seconds) to enter the
BIOS progress mode.
11 Low prole riser right slot N/A Use the card slot to connect half-height PCIe expansion card on low
prole riser. For more information about the PSU congurations, see the
Technical Specications section.
12 Low prole riser left slot
13 Cabled PSU N/A
Dell EMC PowerEdge R440 overview 15

Table of Contents

Related product manuals