Dell EMC PowerEdge R7525 - Removing the Expansion Card Riser (Riser 3 A); Removing the Expansion Card Riser (Riser 4 A)

Figure 92. Removing the expansion card riser (Riser 3A)
3. To remove expansion card Riser 4A:
a. Disconnect the GPU power cable from the system board.
b. Loosen the captive screw.
c. Press the blue release tab and holding the edges lift the expansion card riser from the riser connector on the system board.
Figure 93. Removing the expansion card riser (Riser 4A)
Next steps
1. Replace the full length expansion card riser.
136
Installing and removing system components