Figure 108. Installing the IDSDM module
Next steps
1. Install the MicroSD cards.
NOTE:
Reinstall the Micro-SD cards into the same slots based on the labels you had marked on the cards during
removal.
2. Follow the procedure listed in After working inside your system on page 47.
MicroSD card
Removing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 46.
2. Follow the procedure listed in the Before working inside your system on page 47.
3. Remove the IDSDM module.
Steps
1. Locate the MicroSD card slot on the IDSDM module, and press the card to partially release it from the slot. For more information about
the slot location, see System board jumpers and connectors section.
2. Hold the MicroSD card, and remove it from the slot.
NOTE: Temporarily label each MicroSD card with the corresponding slot number after removal.
Installing and removing system components 149
To Next Page
Loading...
