2. Insert the backplane into the guides and lower the backplane until the blue release tabs clicks into place.
3. Route the cables properly through the cable guide and connect the cables to the connector on the system board.
Figure 52. Installing the drive backplane
Next steps
1. Install the cooling fan cage assembly.
2. Install all the drives.
3. If removed, install the air shroud.
4. Install the drive backplane cover.
5. Connect the drive backplane cables to the connector on the system board.
6. Connect the drive backplane cables to the connector on the backplane.
7. Follow the procedure listed in After working inside your system on page 47.
78
Installing and removing system components
To Next Page
Loading...
