NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
4. Using the Phillips #1 screwdriver, tighten the screws to secure the left control panel and the left control panel cable cover to the
system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 27. Installing the left control panel
Next steps
1. Install the side wall bracket.
2. Install the cooling fan assembly.
3. Install the drive backplane cover.
4. If removed, install the air shroud.
5. Follow the procedure listed in After working inside your system on page 47.
Installing and removing system components
57
To Next Page
Loading...
