b. Twist the cable to 180 degrees to connect the MB_SL3 and MB_SL4 to the J_SL3 and J_SL4 connectors on the system board.
c. Install the cable tie and tighten to fix the cables.
d. To know the XGMI cable connectors on the system board, refer to the System board jumpers and connectors topic.
8. Install the full length expansion card riser or half height expansion card riser. See GPU kit components table for supported GPU risers.
9. Install the GPU air shroud top cover.
10. Install the foam on the system cover. To install the foam,
a. Place the system cover with the System Information Lable (SIL) side facing up.
b. For easier handling, peel off a small section of the adhesive cover and align the foam with the system cover.
c. Remove rest of the adhesive cover, and install foam on the system cover.
d. Press along the length of the foam to ensure that it is firmly affixed to the system cover.
Figure 132. Installing Mylar foam on the system cover
After installing, follow the after working inside the system instructions.
176
Upgrade Kits
To Next Page
Loading...
