3. Remove all the drives.
4. Disconnect all the cables from the rear drive cage.
5. If installed, remove the expansion card riser.
Steps
1. Loosen the captive screws that secure the rear drive cage to the system.
2. Push the guide hole tab to release the rear drive cage from the system and lift the rear drive cage away from the system.
Figure 61. Removing the rear drive cage
Next steps
1. Replace the rear drive cage.
Installing the rear drive cage
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 46.
2. Follow the procedure listed in Before working inside your system on page 47.
Steps
1. Align the guide and slot on the rear drive module with the slot and guide on the system.
2. Insert the rear drive module on top of the Riser 2a.
3. Tighten the captive screws to secure the rear drive cage to the system.
Installing and removing system components
83
To Next Page
Loading...
