4. Connect the intrusion switch cable to the connector on the rear I/O board.
Figure 118. Installing the intrusion switch module
Next steps
1. Install the expansion card riser.
2. Follow the procedure listed in After working inside your system on page 47.
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 46.
2. Follow the procedure listed in the Before working inside your system on page 47.
3. Remove the expansion card riser.
Steps
1. Open the blue latch to disengage the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
158
Installing and removing system components
To Next Page
Loading...
