Dell EMC PowerEdge R7525 - NIC Port Specifications; Serial Connector Specifications; VGA Ports Specifications; Idsdm

NIC port specifications
The PowerEdge R7525 system supports up to two 10/100/1000 Mbps Network Interface Controller (NIC) ports embedded on the LAN
on Motherboard (LOM) and integrated on the optional OCP cards.
Table 70. NIC port specification
Feature Specifications
LOM card 1 GB x 2
OCP card (OCP 3.0) 1 GbE x 4, 10 GbE x 2, 25 GbE x 2, 25 GbE x 4, 50 GbE x 2, 100
GbE x 2
Serial connector specifications
The PowerEdge R7525 system supports one optional card type serial connector, which is a 9-pin connector, Data Terminal Equipment
(DTE), 16550-compliant.
The optional serial connector card is installed similar to an expansion card filler bracket.
VGA ports specifications
The PowerEdge R7525 system supports two DB-15 VGA port one each on the front and back panels.
IDSDM
The PowerEdge R7525 system supports Internal Dual SD module (IDSDM).
The IDSDM supports two SD cards and is available in the following configurations:
Table 71. Supported SD card storage capacity
IDSDM card
• 16 GB
• 32 GB
• 64 GB
NOTE: One IDSDM card slot is dedicated for redundancy.
NOTE: Use Dell EMC branded SD cards that are associated with the IDSDM configured systems.
Video specifications
The PowerEdge R7525 system supports integrated Matrox G200 graphics controller with 16 MB of video frame buffer.
Table 72. Supported front video resolution options
Resolution Refresh rate (Hz) Color depth (bits)
1024 x 768 60 8, 16, 32
1280 x 800 60 8, 16, 32
1280 x 1024 60 8, 16, 32
1360 x 768 60 8, 16, 32
1440 x 900 60 8, 16, 32
Technical specifications 191