Dell EMC PowerEdge R7525 - Installing the Internal USB Card; Intrusion Switch Module; Removing the Intrusion Switch Module

Installing the internal USB card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 46.
2. Follow the procedure listed in Before working inside your system on page 47.
3. Remove the expansion card risers.
Steps
1. Connect the USB key to the internal USB card.
NOTE: Ensure to install the internal USB card in the IDSDM/USB card slot and not in the J_R3_PCIE_PWR
connector slot.
2. Align the internal USB card with the connector on the system board and press firmly until the internal USB card is seated.
Figure 116. Installing the internal USB card
Next steps
1. Install the expansion card risers.
2. Follow the procedure listed in After working inside your system on page 47.
3. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Intrusion switch module
Removing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions on page 46.
2. Follow the procedure listed in the Before working inside your system on page 47.
3. Remove the expansion card riser.
156
Installing and removing system components