Table 6. Rear view of the system with 2 x 2.5-inch rear drive module (continued)
Item Ports, panels, or slots Icon Description
To reset iDRAC, press and hold the button for more than 16 seconds.
NOTE:
• To reset iDRAC using system ID, ensure that the system
ID button is enabled in the iDRAC setup.
• If the system stops responding during POST, press and
hold the system ID button (for more than 5 seconds) to
enter the BIOS progress mode.
12
OCP NIC port (optional) N/A This port supports OCP 3.0. The NIC ports are integrated on the OCP
card which is connected to the system board.
13 NIC port (1,2) The NIC ports are embedded on the LOM card that is connected to the
system board.
14 Power supply unit (PSU 1) For more information about the PSU configurations, see the Technical
Specifications section.
For more information about the ports, see the Technical Specifications section.
Inside the system
Figure 11. Inside the system
1.
Handle 2. Riser 1 blank
3. Power supply unit (PSU 1) 4. Riser 2
22 System overview
To Next Page
Loading...
