Steps
1. Slide and insert the hard-drive cage into the slot on the chassis.
2. Install the four (#6-32) screws to secure the hard-drive cage to the chassis.
3. Connect the SATA power-cables and SATA data-cables to the connectors on the system board.
Next steps
1. Install the bottom air-shroud
2. Install the hard-drive fan assembly.
3. Install the 3.5-inch hard-drive assembly.
4. Install the 2.5-inch hard-drive assembly.
5. Install the air shroud.
6. Install the side cover.
7. Follow the procedure in After working inside your computer.
Rear fans
Removing the rear-fan assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the air shroud.
About this task
The following images indicate the location of the rear-fan assembly and provide a visual representation of the removal
procedure.
54
Removing and installing components
To Next Page
Loading...
