System Setup 83
LPT Port Mode
(PS/2 default)
Determines the mode of operation of the internal
parallel port.
•
Off
disables the port.
•
AT
configures the port for AT compatibility.
•
PS/2
configures the port for PS/2 compatibility.
•
EPP
configures the port for the EPP bidirectional
protocol.
•
ECP
configures the port for the ECP bidirectional
protocol.
NOTE: If you set the LPT Port Mode to ECP, the LPT Port
DMA appears in the option menu.
LPT Port Address Determines the address that the built-in parallel port
uses.
Serial Port #1
(Auto default)
Determines how the serial port operates.
Auto, the default setting, automatically configures a
connector to a particular designation (COM1 or
COM3).
Serial Port #2
(Auto default)
Determines how the serial port operates.
NOTE: Only available if a PS/2 serial port adapter is
installed.
Auto, the default setting, automatically configures a
connector to a particular designation (COM2 or
COM4).
Video
Primary Video
(Auto default)
This setting specifies which video controller is primary,
Auto or Onboard/PEG. When Auto is selected, the
add-in video controller will be used.
NOTE: A PCI Express Graphics (PEG) card will override
the integrated video controller.
To Next Page
Loading...
