Dell PowerEdge R930 - Page 156

4 Remove the following:
a Hard drives
b Memory risers
c Cooling fans
d Memory riser and fan cage
e SAS expander daughter card
NOTE: Not applicable for the 2.5 inch (x4) SAS/SATA backplane
conguration.
5 Disconnect the SAS/SATA/SSD data, signal, and power cables from the backplane and system board.
Steps
1 Push the release tabs in the direction of the arrow.
2 Lift the backplane away from the system until the hooks and slots on the backplane disengage from the hooks and slots on the
chassis.
Figure 88. Removing the 2.5 inch (x4) SAS/SATA backplane
1
SAS connector 2 release tab (2)
3 hard drive connector (4) 4 backplane hook (4)
5 guide 6 backplane power cable
7 power connector on the system board 8 memory riser guide
156 Installing and removing system components