Figure 94. Cabling— x24 backplane with dual PERC and dual SAS expander cards
1
SAS cable connector on the primary integrated storage
controller card
2 integrated storage controller card (primary card)
3 integrated storage controller card (secondary card) 4 SAS cable connector on the secondary integrated
storage controller card
5 x24 hard drive backplane 6 primary daughter card SAS B connector
7 primary daughter card SAS A connector 8 secondary daughter card SAS B connector
9 secondary daughter card SAS A connector
Next steps
1 Install the hard drive backplane.
2 If removed, install the front bezel.
3 Follow the procedure listed in the After working inside your system section.
162
Installing and removing system components
To Next Page
Loading...
