Installing The Input/Output Board
1. Place the Input/Output (IO) board on the computer and ensure the
connector is properly engaged to the matching connector on the system
board.
2. Tighten the screw securing the IO board in place.
3. Connect the ExpressCard cable.
4. Install the
palm rest
.
5. Install the
secondary hard drive
.
6. Install the
primary hard drive
.
7. Install the
optical drive;
.
8. Install the
keyboard
.
9. Install the
keyboard trim
.
10. Install the
base cover
.
11. Install the
battery
.
12. Follow the procedures in
After Working Inside Your Computer
.
71
To Next Page
Loading...
