Dell Precision M6600 - Installing the Touchscreen Display Panel

Installing The Touchscreen Display Panel
1. Align the display bracket with the display panel and tighten the four screws
securing the display bracket in place.
2. Place the digitizer board in the computer.
3. Tight the screws securing the digitizer board in place.
4. Connect the digitizer cable.
5. Connect the low-voltage differential signaling (LVDS) cable to the back of
the display panel and replace to adhesives securing the LVDS cable in
place.
6. Tighten the screws securing the display panel in place.
7. Tighten the screws on the left side of the display panel securing the display
panel in place.
8. Install the
touchscreen display Bezel .
9. Install the battery .
10. Follow the procedures in After Working Inside Your Computer .
94