Dell Precision M6600 - Installing the Display Panel

10. Remove the display bracket.
Installing The Display Panel
1. Align the display bracket with the display panel and tighten the screws
securing the display bracket in place.
2. Connect the low-voltage differential signaling (LVDS) cable to the back of
the display panel and replace to adhesives securing the LVDS cable in
place.
3. Tighten the screws securing the display panel in place.
4. Tighten the screws on the left side of the display panel securing the display
panel in place.
5. Install the display bezel .
6. Install the battery .
7. Follow the procedures in After Working Inside Your Computer .
99