Delphi Multec 3.5 - Page 177

Multec 3.5 Fuel Injector Application Manual Index
Delphi Energy and Chassis Systems
Revision: 11/05-1 11-7
Testing ..................................................................1-2
Durability..........................................................9-1
Icing..................................................................8-5
Recommendations and precautions ..................8-1
Spark Plug Fouling...........................................8-5
Standard Durability ..........................................8-5
Standard Vehicle Development ........................8-2
Validation .........................................................9-1
Thermal Conductivity...........................................3-2
Thermocouples .....................................................7-1
Three-way catalyst................................................2-5
Tip Icing .............................................................2-18
Tip Leakage.............................................. 3-34, 3-35
Top Speed Limiters ............................................5-14
TPS .....................................................................5-11
Transient Conditions ..........................................5-12
U
Usage Definition...................................................3-3
USCAR....................................................... 4-11, 7-7
V
Vacuum bias .............................2-16, 3-14, 5-7, 5-10
Vacuum biased regulator......................................5-7
Validation .............................................................9-1
Matrix ...............................................................9-6
Requirements....................................................9-1
Valve Stroke .......................................................3-37
Vaporization .........................................................2-8
Verification(Validation Matrix) ...........................9-7
Vibration............................... 3-2, 3-40, 4-3, 8-1, 9-5
Durability Requirements...................................4-5
Measurement Techniques.................................4-5
Viton GLT ............................................................3-7
Voltage .................................................. 6-1, 6-6, 9-5
Offset ..............................................................2-28
Sensitivity .........................................................8-5
System .................................................. 2-21, 3-28
System Errors .................................................5-19
Volumetric efficiency............................... 5-10, 5-19
W
Wall Wetting, Fuel Puddling..............................5-13
Water or Steam.....................................................7-3
Wear and Contamination......................................7-3
Wide-open throttle..............................................2-19
Wire Routing ........................................................4-9
Wiring.................................................................5-17
Wiring Resistance and Connector Resistance ....3-28
Working Flow Range .............2-14, 2-20, 3-17, 3-33
World Wide Fuel Charter ........................... 1-6, 2-10
X
X intercept ............................................................5-6