Denon AVR-4310CI - Radio Tuning: SIRIUS Satellite Radio; SIRIUS Satellite Radio Tuning and Signal Check


Getting Started Connections Settings Remote ControlMulti-zone Information Troubleshooting Specifi cations
Tuning in Radio Stations – SIRIUS Satellite Radio
Presetting Radio Channels (Preset Memory)
Your favorite broadcast channels can be preset so that you can tune
them in easily. Up to 56 channels can be preset.
To preset other channels, repeat steps 1 to 4.
NOTE
Preset channels are erased by overwriting them.
Listening to Preset Channels
You can also operate via the main unit. In this case, perform the
following operations.
Press <TUNING PRESET>, then turn <SOURCE SELECT> to select the
preset radio channel.
Press [CHANNEL] to select the desired preset channel,
then press ENTER.
Selection is still possible if you press [1 ~ 8] after pressing [A ~
G].
b
1
Tune in the broadcast channel you want to preset.
2
Press [MEMO].
3
Press [A ~ G] to select the block in which the channel
is to be preset, then press [CHANNEL] or [1 ~ 8] to
select the preset number.
The memory block can also be selected by pressing [SHIFT] on
the sub-remote unit.
b
4
Press [MEMO] again to complete the setting.
<SOURCE SELECT>
<STATUS>
<TUNING PRESET>
ENTER
uio p
ENTER
[SEARCH]
[CHANNEL]
[A ~ G]
[0 ~ 9]
[SAT TU]
[MEMO]
[TUd]
[TU f]
[ SAT TU]
uio p
[SOURCE
SELECT]
Button located on both the main unit
and the remote control unit BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
The strength of both the SIRIUS satellite and terrestrial signals can be
checked “Antenna Aiming” (vpage 52).
Checking the SIRIUS Signal Strength and Radio ID
1
Press <STATUS> until “SIGNAL” appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display Status
EXCELLENT Signal strength is excellent
GOOD Signal strength is good
WEAK Signal strength is weak
NO SIGNAL No signal
2
Adjust the position of the antenna until “SIGNAL:
EXCELLENT” is shown on the display.
3
Press <STATUS> until the channel (example:
“SR001”) is displayed.
4
Press [TU d] or [TU f] and select channel 0 (SR000).
Channel No. and Sirius ID are alternately shown on the display.
S R 0 0 0 S i r i u s I D
* * * * * * * * * * * *
Write your own SIRIUS ID for storage use.
Sirius ID :
b
Sirius ID
[CHANNEL]
[A ~ G]
[1 ~ 8]
[MEMO]
[MODE]
[BAND]
[TUd]
[TU f]
[ DTU]
uio p
[DTU]
[SOURCE
SELECT]
[SHIFT]
[DTU]
[SAT TU]
Sub remote control unit
Playback
(MAIN mode)
(MAIN mode)
(MAIN mode)
(MAIN mode)
1.AVR4310CIEU.indd 59 2009/04/14 16:37:37