Getting Started Connections Settings Playback Multi-zone Information Troubleshooting Specifications
Operating the Main Remote Control Unit
If your AV devices are of a brand other than DENON or if they cannot
be operated with the preset memory function, their remote control
signals can be transfered to stored in the AVR-4310CI’s main remote
control unit.
Learning Function
1
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
2
Press [9], [7] and [5], in that order.
The signal transmission indicator flashes twice and the learning
mode is set.
3
Press [DEVICE SELECTOR] for the device you want
to set
4
Press the button to be set.
The main remote control unit’s display turns off.
If a button that cannot be learned is pressed, the signal transmission
indicator lights but the signal is not learned.
b
5
Point the main remote control units directly at each
other and press and hold the button on the other
device’s remote control unit that you want to learn.
Once learning is completed normally, the display lights and the
signal transmission indicator flashes twice.
If you want to learn other buttons, repeat steps 4 and 5.
The mode can be switched by pressing [DEVICE SELECTOR].
The signal transmission indicator lights once for a long time if
learning was not possible
b
b
b
6
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice and the setting
is completed.
With some remote control units, the signals cannot be learned or the
device will not operate properly even when the signals have been
learned. In this case, use the device’s own remote control unit.
Learned buttons have priority over the preset memory. If you no
longer need the learned setting, reset the learning function (vpage
96).
•
•
NOTE
[POWER ON], [POWER OFF] and [SOURCE SELECT] cannot be
learned.
Do not learn any remote control signals at [RC SETUP].
The MAIN, ZONE2, ZONE3, ZONE4 and MACRO modes cannot be
learned.
Codes cannot be learned at [MASTER VOLUME] or [MUTE] when
the main remote control unit is set to “TUNER”, “SAT TU”, “DTU”,
“NET/USB” or “iPod”.
•
•
•
•
This function lets you register a series of operations at a single
button.
For example, the amplifier can be turned on, the input source selected,
the monitor’s power turned on, the source device’s power turned on
and the play mode set all by pressing a single button.
Up to 32 signals each can be registered at [MACRO] (1 ~ 3).
MACRO Function
1
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
2
Press [9], [7] and [8], in that order.
The signal transmission indicator flashes twice and the system
call registration mode is set.
3
Press [MACRO] (1 ~ 3) at which you want to register
the signals.
4
Press the buttons you want to register in the same
sequence as the operations you want to perform.
The signal transmission indicator lights when a button is
pressed.
Example : Press [POWER ON].
↓
Press [DEVICE SELECTOR] – [DVD/HDP].
↓
Press [1].
The mode can be switched by pressing [DEVICE SELECTOR].
Perform the registration procedure for all the buttons you want
to register.
b
b
5
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice and the setting
is completed.
NOTE
Registration is not possible in ZONE2, ZONE3, ZONE4 and MACRO
modes.
Registering
Remote Control
1.AVR4310CIEU.indd 94 2009/04/14 16:38:22
To Next Page
Loading...
