Denon AVR-4310CI - Sub Remote: Zone and Remote ID Reset; Zone Switching and Remote ID Resetting


Getting Started Connections Settings Playback Multi-zone Information Troubleshooting Specifications
Operating the Main Remote Control Unit
[0 ~ 9]
[CHANNEL +, –]
[ DVD/HDP]
[ SAT/CBL]
[ VCR/DVR]
[ TV]
[DEVICE
SELECTOR]
[8], [1],
[9], [6],
[3], [7], [2]
[RC SETUP]
[ MAIN]
Calling out
DVD/HDP (including BD and CD) or DVR/VCR mode buttons can be
stored at unused TV or SAT/CBL mode buttons.
For example, when DVD mode buttons are assigned to the TV mode,
the DVD mode operations can be performed while in the TV mode.
Punch Through Function
1
Press [MAIN], to select “MACRO”.
2
Press [MACRO] (1 ~ 3) at which the signals were
registered.
The registered signals are transmitted in the registered
sequence.
1
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
2
Press [9], [8] and [8], in that order.
The signal transmission indicator flashes twice and the punch
through setting mode is set.
3
Press [DEVICE SELECTOR] for the device you want to
punch through ([DVD/HDP] or [VCR/DVR]).
4
Press the button you want to punch through ([1],
[2], [6], [7], [8], [9] or [3]).
Each time the button is pressed, the signal transmission
indicator flashes once.
5
Press [DEVICE SELECTOR] for the device you want to
punch through ( [TV] or [SAT/CBL]).
6
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice and the setting
is completed.
The display’s brightness can be adjusted in 5 steps.
(Default: Step 5)
Adjusting the Backlight’s Brightness
Setting the Time the Backlight Stays Lit
1
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
2
Press [CHANNEL +] or [CHANNEL –].
The display gets one step brighter when [CHANNEL +] is
pressed.
The display gets one step darker when [CHANNEL –] is
pressed.
3
Press [RC SETUP] to complete the setting.
1
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
2
Press [9], [7] and [3], in that order.
The signal transmission indicator flashes twice and the backlight
on time setting mode is set.
3
Set the light on time.
The signal transmission indicator flashes twice.
[Settable times] : [1] : 5 sec.
[2] : 10 sec. (Default)
[3] : 15 sec.
[4] : 20 sec.
[5] : 25 sec.
Signal
transmission
indicator
[MACRO]
Remote Control
1.AVR4310CIEU.indd 95 2009/04/14 16:38:23