Error
Code
Details of Error code Display Coping strategies
5B
NACK was received when "L"
command sent to DSP, PLD etc.
U p d a t i n g f a i l 5 B
Turn off and on the power.
Updating starts automatically.
5C
DSP, PLD etc. failed to receive
rmware for rewriting sent from
DM860A (when timed out).
U p d a t i n g f a i l 5 C
Turn off and on the power.
Updating starts automatically.
5D
DSP, PLD etc. failed to receive
rmware for rewriting sent from
DM860A (when an error occurred).
U p d a t i n g f a i l 5 D
Turn off and on the power.
Updating starts automatically.
5E
Data in rmware such as DSP
and PLD for rewriting sent from
DM860A was invalid (when a Check
Sum error occurred).
U p d a t i n g f a i l 5 E
Turn off and on the power.
Updating starts automatically.
5F
Invalid data in rmware such as DSP
and PLD for rewriting sent from
DM860A was invalid (invalid data
was received).
U p d a t i n g f a i l 5 F
Turn off and on the power.
Updating starts automatically.
60
NACK was received when "P"
command sent to DSP, PLD etc.
U p d a t i n g f a i l 6 0
Turn off and on the power.
Updating starts automatically.
61
NACK was received when "I"
command sent to DSP, PLD etc.
U p d a t e C h e c k N G 6 1
Turn off and on the power.
Updating starts automatically.
80
Acquisition of serial ash data failed
before serial ash was deleted.
U p d a t i n g f a i l 8 0
Turn off and on the power.
Updating starts automatically.
81
Deleting data failed before serial
ash was rewritten.
U p d a t i n g f a i l 8 1
Turn off and on the power.
Updating starts automatically.
82
Receiving rmware for rewriting
serial ash sent by DM860A failed
(when timed out).
U p d a t i n g f a i l 8 2
Turn off and on the power.
Updating starts automatically.
83
Receiving rmware for rewriting
serial ash sent by DM860A failed
(when an error).
U p d a t i n g f a i l 8 3
Turn off and on the power.
Updating starts automatically.
84
Receiving rmware for rewriting
serial ash sent by DM860A failed
(when a Check Sum error).
U p d a t i n g f a i l 8 4
Turn off and on the power.
Updating starts automatically.
85
Receiving rmware for rewriting
serial ash sent by DM860A failed
(when invalid data was received).
U p d a t i n g f a i l 8 5
Turn off and on the power.
Updating starts automatically.
86
The data verication was invalid
after serial ash was rewritten.
U p d a t i n g f a i l 8 6
Turn off and on the power.
Updating starts automatically.
A0
Acquisition of (Application Mode) IP
address failed before DM860A was
rewritten (AutoIP).
C o n n e c t i o n F a i l A 0
Check the network connection.
Carry out the update in an
environment that has little network
load.
A1
Acquisition of (Application Mode) IP
address failed before DM860A was
rewritten (when timed out).
C o n n e c t i o n F a i l A 1
Check the network connection.
Carry out the update in an
environment that has little network
load.
63
To Next Page
Loading...
Need help?
General
