ENGLISH
Audio Setup
Setting items
Setting contents
Setting items Setting contents
-,
;;
'J
i.
I
• When outputting
CD,
etc,
to
a digital recording device, such
as
a
CD
recorder, convert
to
PCM or PCM
down
sampling.
• When a disc with recorded Linear PCM or PPCM (packed PCM) is played
back, this outputs Linear PCM regardless
of
the setting.
Aut2 : Outputs the primary audio (main audio)
in
the same type
of
audio
format. Dolby Digital/Dolby Digital Plus/Dolby TrueHD are
output
as
Dolby Digital, DTS/DTS-HD are output
as
DTS
and Linear PCM is output
as
Linear PCM.
Dolby Digital:Outputs
to
the digital audio
output
terminal (optical/
coaxial)
with
Dolby Digital.
DTS : Outputs to the digital audio output terminal (optical/coaxial) with
DTS.
~
Valid when "BD Audio
Mode"
is set
to
"Mix
Audio
Output"
((W'page
32)
Bitstream : Outputs a bitstream signal. Converts Dolby TrueHD, Dolby
Digital Plus
to
Dolby Digital. and DTS-HD to
DTS
for
output.
PCM : Outputs the
downmixed
audio signal to 2-ch LPCM.
PCM Down Sampling: Converts sampling frequency audio greater than
48
kHz
to a 48
kHz
2-ch LPCM audio
output
signal.
In
order
to
enable
the
"Lt/Rt" setting when playing back
BD,
set "BD
Audio
Mode"
to
"HD Audio
Output"
((W'page
32).
LtLBt
: Signals are converted
to
Dolby Surround compatible 2-channel
audio signals for output. This setting
is
valid for DTS-HD,
DTS
Digital
Surround, Dolby Digital Plus and Dolby Digital audio signals. (If
the
connected
AV
Amp is Dolby
Pro
Logic compatible, the
AV
Amp
plays
back using surround audio.)
Stereo: Outputs by converting
to
2-ch (stereo) audio,
'Nen
a
BD
Re·Encoder
Sets the format during
output
of
the
BD's
Mix
Audio signal from the digital
output terminal.
Digital
Out
Sets
the
audio signal
of
digital audio output.
For
more information on each
audio signal. refer
to
"Audio
Signal from the Digital Audio
~
Output (Optical/Coaxial)
Terminal"
(l?Fpage
17).
Downmix
Sets the method used
to
convert a multi-channel
audio signal
to
a 2-channel
signal.
Off
: Enables the speaker and subwoofer settings.
On
:
50kHz:
Outputs the disc content
as
is.
When playing Super Audio
CD.
outputs up to 50
kHz
audio signals.
On
: 100kHz: Outputs the disc content
as
is.
When playing Super Audio
CD,
outputs up to 100
kHz
audio signals.
~
• Setting "On:
50
kHz" or "On: 100 kHz" enables full-range playback
on all channels recommended for
DTS.
(Note that this results
in
a 5
dB increase in
subwoofer
volume, and a
15
dB increase
with
Super
Audio CDs). This also allows you
to
play back the 6-channel source of
DVD-Audio recorded on
all
channels with the full frequency range.
In
this case, make analog connections according
to
the disc operating
manual.
• When set
to
"On: 50 kHz" or "On: 100 kHz", all speaker sizes are set
to
"Large" and "Yes" is set for the subwoofer.
• Even when set
to
"On: 50 kHz" or "On: 100 kHz", the "Channel Level"
and "Distance" settings
can
be made.
Aut2 : Automatically compresses the Dolby TrueHD audio dynamic
range. The sound is not compressed when playing signals other than
Dolby TrueHD signals.
Off : Dynamic Range compression is not applied.
Low:
Sets
minimum
dynamic range compression.
Middle:
Sets medium dynamic range compression.
High:
Sets maximum dynamic range compression.
Qn..:
Outputs
BD
effect sound.
Off:
Does
not
output
BD
effect sound.
Compression
Compresses
the
dynamic
range
of
Dolby TrueHD/
Dolby Digital/Dolby Digital
Plus audio. At night or other
times
when
you cannot play
back at high volume, this
compensates by reducing
high level sounds and
increasing
low
level sounds.
BD
Effect Sound
Sets for a clicking and other
sound
outputs
during
BD
popup menu operation.
Source Direct
Disables
the
speaker and
subwoofer
settings and
outputs
the
disc audio
as
is.
'NeUa
Set
to
within
the
playback
frequency band
of
the
amplifier you will use:
"On" at "50 kHz" or "100
kHz". Settings outside the
frequency band can result
in
damage
to
your amplifier
and even fire.
Remote control operation
buttons
SETUP
CD
.Displays the menu
'Cancels the menu
.Moves the cursor
'(Up/Down/Left/Right)
8
:Makes the setting
RETURN
o
:Returns
to
previous menu
27
To Next Page
Loading...
Need help?
General
