ENGLISH
I
Remote Control Settings (Remote,
Control Side)
2 : Set the remote control code to "2".
Switches when the DBP·A100's remote control operates another
DENON
BD
players
in
the vicinity.
Set the remote control code simultaneously on the main unit, too.
For
instructions
on
setting codes, see
GUI
menu: "Other Setup" -
"Remote Control Setting" - "Remote
10"
(&page
31).
• If the signal code of the remote control does not match the signal
code of the unit. the remote control code set
on
the unit
is
shown
on
the display.
[Example]
If the code setting on the unit
is
·'OENON 1", and the setting
on
the
remote control
is
"2",
"PLAYER
1"
is
shown
on
the display.
[Remote control code setting]
: Set the remote control code to "1".
'N,nw
• Match the signal code of the remote control with the signal code of
the unit. If the remote control code is different. you cannot operate
the
OBP-A
100 with the remote control.
•
Even
if you change the remote control code, set the
GUI
menu
"Other Setup" - "Remote Control setting" - "Receive Legacy
Remocon"
(~page
31)
to "Off" when operating the
OBP-A
100
with a remote control other than OENON's.
Approx.23feetl7m
'N,nw
The set may function improperly or the remote control may not
operate if the remote control sensor
is
exposed to direct sunlight,
strong artificial light from
an
inverter type fluorescent lamp or infrared
light.
About the Remote Control
<Ii
Put
the rear cover back
on.
,~[,nw
•
Use
R6/AA batteries
in
this remote control.
• Replace the batteries with new ones if the set does not operate
even
when the remote control
is
operated close to the unit. (The
supplied batteries
are
only for verifying operation.)
•
Be
sure to insert the batteries
in
the proper direction, following the
"®" and
"e"
marks
in
the battery compartment.
•
To
prevent damage or leakage of battery fluid:
Do
not use a new battery with
an
old
one.
Do
not use
two
different types of batteries.
Do
not attempt to charge dry batteries.
Do
not short-circuit. disassemble, heat or dispose of batteries
in
a fire.
• If the battery fluid leaks, carefully wipe the fluid off the inside of the
battery compartment
and
insert new batteries.
• Remove the batteries from the remote control if it will not
be
used
for a long time.
• Used batteries should be disposed of
in
accordance with local
regulations on battery disposal.
IInserting the Batteries I IOperating Range of the Remote Control
CD
Remove the rear cover.
(1)
Set three R6/AA batteries
in
Operate the remote control while pointing it at the remote sensor.
the battery compartment
in
the
indicated direction.
7
To Next Page
Loading...
Need help?
General
