EasyManua.ls Logo

Deutz 1012 - Page 102

Deutz 1012
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting 7.1 Diagnosis Chart
7
●●
●● ●●
●●
●●●●● ●●
●● ●●
●● ●●
●●
●●
Fault Remedy
Engine fails or is difficult to start Check P
Engine starts but runs unevenly or stalls Adjust E
Engine overheats. Temperature monitor gives warning Replace W
Engine gives poor performance Clean R
Engine not firing on all cylinders Top up A
Engine has little or no oil pressure Lower level S
Engine oil consumption excessive
Engine smokes - blue
- white
- black
Section
Cause
Electrics cable connections to starter, electrical system loose or oxidized Electrics P
Starter defective or pinion does not engage P
Incorrect valve clearance Engine E
Leaking injection line P
Vent pipe blocked (coolant heat exchanger) P / R
Glow plugs defective P
Injector defective P / W
Air in fuel system P / W
Fuel filter/prefilter dirty P/ R /W
Oil filter defective W
Incorrect lube oil SAE class or quality
Operating media
W
Fuel quality not as per Operation Manual P/ W
Coolant level too low P/ A
Table 2 of 2

Table of Contents

Related product manuals