ENGLISCH • Kapitel 6 • Seite 73
6
© 2002
Never clean air cleaner with
gasoline. Dispose of old oil in
accordance with environmen-
tal regulations.
6.4.2 Emptying Cyclone Type
Precleaner
z Turn engine off and wait about 10 minutes
for the oil to drain from filter housing 1.
z Release snap clips 2 and remove oil cup 3
together with filter element 4. If necessary
prize element out with a screwdriver,
taking care not to damage the rubber
gasket 5.
z Remove dirty oil and sludge. Clean oil cup.
z Clean filter element 4 in diesel fuel and
allow to drip-dry.
z Undo wing nut 1 and remove cover 2.
z Remove collector bowl 3 from lower sec-
tion 4 and empty. Clean leaves, straw and
other foreign matter from lower section of
precleaner.
z Reposition collector bowl 3 onto lower
section 4, fasten cover 2 in place by
tightening wing nut 1.
z Clean filter housing 1 if very dirty.
z Inspect and replace rubber gaskets 5 and
6 if necessary.
z Fill oil cup with engine oil up to the mark
(arrow) (for viscosity, see 4.1.2).
z Refit oil cup and element to filter housing
and secure with snap clips.
6.4.3 Cleaning Oil Bath Air
Cleaner
Never fill collector bowl with oil. Replace
collector bowl if damaged.
© 25 886 0 © 25 887 0
6.4 Combustion Air Cleaner Service and Maintenance
9682en_K06.p65 17.11.2008, 12:2173