EasyManua.ls Logo

Deutz 1012 - Three-Phase Alternator; Lifting Tackle

Deutz 1012
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGLISCH • Kapitel 6 • Seite 86
6
© 2002
Use only the correct lifting
tackle.
6.7.2 Three-Phase Alternator 6.7.3 Lifting Tackle
Notes on the three-phase system:
z Never disconnect the cables between bat-
tery, alternator and regulator while the engine
is running.
z If, however, it is necessary to start and ope-
rate the engine without the battery, discon-
nect the regulator from the alternator before
starting.
z Be sure not to confuse the battery terminals.
z Replace defective bulb of the charge pilot
lamp immediately.
z Cleaning the engine: Do not spray water/
steam directly onto the alternator. Run the
engine up to normal operating temperature to
evaporate any remaining water.
z The habit of touching a lead against the frame
to check whether it is live must under no
circumstances be used with three-phase
electrical systems.
z In the case of electric welding, connect the
ground terminal on the welder directly to the
piece being welded.
z Always use proper lifting tackle when
transporting the engine.
© 26 265 0
Service and Maintenance 6.7 Accessories
© 26 264 0
9682en_K06.p65 17.11.2008, 12:2186

Table of Contents

Related product manuals