194
Part # 8533-072-001 3/22
Preventative Maintenance
Daily
Step 1: Check that the loading door remains securely locked and cannot be opened during an entire
cycle.
Step 2: Clean the top, front, and sides of the cabinet to remove residue.
Step 3: Clean the soap dispenser and lid and check that all dispenser mounting screws are in-place and
tight.
Step 4: Check the loading door for leaks. Clean the door seal of all foreign matter.
Step 5: Leave the loading door open to aerate the washer when not in use.
Quarterly
Step 1: Make sure the washer is inoperative by switching o the main power supply.
Step 2: Check the V-belts for wear and proper tension.
Step 3: Clean lint and other foreign matter from around motor.
Step 4: Check all water connections for leaks.
Step 5: Check the drain valve for leaking and that it opens properly.
Step 6: Wipe and clean the inside of the washer and check that all electrical components are free of
moisture and dust.
Step 7: Remove and clean water inlet hose lters. Replace if necessary.
Step 8: Check anchor bolts. Retighten if necessary.
To Previous Page
Loading...
Need help?
General
