Operating instructions, SM-110/-111
Servicing and maintenance
35
8
8.1 Clean the machine
The machine must be cleaned after each work session. In order to obtain
good grinding results at all times, always keep the machine clean,
especially the knife guides.
CAUTION
RISK OF INJURY FROM ROTATING MACHINE PARTS
If the machine is accidentally switched on during maintenance
work, there is a risk of injury due to rotating machine parts.
➾ Always pull the mains plug before carrying out any mainte-
nance work.
4
1
5
3
2
[14-1] Honing wheels
[14-2] Plastic housing
[14-3] Water tank
[14-4] Clamp
[14-5] Handle
Image 14 – Clean the machine
1. Remove residual abraded material from the machine, e.g. using a brush.
2. Depending on the degree of contamination, clean the honing wheels
[14-1] with a cleaning cloth soaked in washing-up liquid or alcohol. While
doing so, turn the honing wheels by hand.
3. Clean the plastic housing [14-2] from grinding dust only with a soft brush.
➾ Abrasive grains cause scratches on the housing even when using a soft
cloth.
4. Clean the water tank [14-3] daily after use and keep it dry. To this end,
open both clamps [14-4] and lift the machine out of the water tank using
both handles [14-5].
To Next Page
Loading...
