Dick SM-110 - Replacing Water Stripping Brush

Operating instructions, SM-110/-111
Servicing and maintenance
47
8
2. SM-110: Continue with step 7.
Only for SM-111:
3. In addition, attach the star handle [27-3].
4. Installtheange[27-2]incl.ttingscrew.
5. Screw in the three countersunk screws [27-1] with the enclosed Phillips
screwdriver.
6. Installing the polishing wheel (see 8.7 Replacing the polishing wheel (only
for SM-111)).
SM-110 and SM-111:
7. Insert the mains plug.
8. Switch on the machine and test run it for one minute. In case of unusual
behaviour, switch off the machine immediately and check all individual
parts for proper condition and assembly.
8.9 Replacing water stripping brush
If the grinding wheels splash water, check the position and condition of the
brushes [28-1] on the knife guides [28-5]. Worn water stripping brushes
must be replaced. Always replace the left and right brush units at the same
time, as both wear out equally.
CAUTION
RISK OF INJURY FROM ROTATING MACHINE PARTS
If the machine is accidentally switched on during maintenance
work, there is a risk of injury due to rotating machine parts.
➾ Always pull the mains plug before carrying out any mainte-
nance work.