Dick SM-110 - Dressing the Grinding Wheel

Operating instructions, SM-110/-111
Servicing and maintenance
36
8
8.2 Dressing the grinding wheel
If the grinding wheels are very dirty or if there is noticeable lateral runout
(imbalance), the grinding wheels need to be dressed. The dressing device
consists of: Dressing spindle with diamond, swivel lever and retaining screw.
2
3
1
[15-1] Dressing spindle with diamond
[15-2] Swivel lever
[15-3] Retaining screw
Image 15 – Dressing device
4
2
3
1
5
6
Image 16 – Dressing the grinding wheels
[16-1] Screw plug
[16-2] Guidance
[16-3] Star handle screw and washer
[16-4] Knife guide
[16-5] Dressing device with retaining screw
[16-6] Dressing spindle
1. Lift the machine out of the water tank.
2. Remove the screw plug [16-1] on the front side of the guide [16-2].
Remove star handle screw and washer [16-3] and pull off the knife guide
[16-4].
3. Attach the dressing device with retaining screw [16-5]andtightenrmly.
4. Put the machine back into the water tank.
5. Before switching on the machine, make sure that the dressing spindle
[16-6] and the diamond are not touching the grinding wheel.