OPERATOR’S MANUAL
PM200, 200E and 250 Planter Monitors
11001-1444-200702
ALARMS / 41
SENSOR SELF-TEST
The Sensor Self Test activates at every power cycle comparing configured
number of rows to number of rows detected. Any sensor not found during
self-test or inaccurate configuration will sound the self-test failure alarm.
The alarm can be acknowledged by pressing the Alarm Cancel key, but will
re-activate at each powerup until the problem is resolved.
Figure 35
Self Test Failure Display
HI GROUND SPEED EXCEEDED (PM250)
The Hi Ground Speed Exceeded alarm is triggered anytime the speed has
exceeded the speed entered in the Ground Speed Setup screen. Alarm can
be silenced by pressing the Alarm Cancel key.
Figure 36
Maximum Speed Exceeded Warning Display
2 4 5 6
SELF TEST FAILURE
7 8 9
10
11
12
HI GROUND SPEED
To Next Page
Loading...
