DIESTRO 103APV4R ELECTROLYTE ANALYZER
38 JS Medicina Electrónica
By clicking on the electrode enable button, you will be able to enable or disable it.
In this window you can also select the units of measurement. In the case of pH, you can select
the temperature at which the result will be reported (37°C or Tamb)
8.2 Configuring the measurement correction
The correction equation allows you to fine tune the values measured by the analyzer, in such a
way that they coincide with those obtained with other equipment, internal and external quality
controls or with the desired Standard.
Before using Corrections, verify the correct operation of the analyzer and
perform quality control.
Never apply Corrections if the equipment is not in perfect working condition.
See the "QUALITY CONTROL" section
To Next Page
Loading...