XBee®-PRO 900HP/XSC RF Modules
10
FIRMWARE_VERIFY_RESPONSE (0x85) 179
FIRMWARE_VERIFY _AND_INSTALL_RESPONSE (0x86) 179
Work with flash memory 180
XSC firmware
XBee-PRO XSC RF Module overview 182
Pin signals 182
Electrical characteristics 183
Timing specifications 184
XBee-PRO XSC specifications
Performance specifications 188
Power requirements 188
Networking specifications 189
General specifications 189
Antenna options 189
Regulatory conformity summary 190
XBee-PRO XSC RF Module operation
Serial communications 192
UART-interfaced data flow 192
Serial data 192
Flow control 192
Data In (DIN) buffer and flow control 193
Data Out (DO) buffer and flow control 194
Operating modes 194
Idle mode 194
Transmit mode 195
Receive mode 195
Sleep mode 195
Command mode 198
Configuration and commands
Programming examples 203
Connect the device to a PC 203
Send binary commands 203
Example 203
Special commands 204
FR (Force Reset) 204
PL (TX Power Level) 204
Command mode options 204
AT (Guard Time After) 205
BT (Guard Time Before) 205
CC (Command Sequence Character) 205
CD (DO3 Configuration) 206
CN (Exit Command Mode) 206
CT (Command Mode Timeout) 207
E0 (Echo Off) 207
E1 (Echo On) 207
To Next Page
Loading...
Need help?
General
