Digi XBEE-PRO S3B - P3 (Dio13 Dout); P4 (Dio14 Din); PD (Pull UpDown Direction)

AT commands I/O settings commands
XBee®-PRO 900HP/XSC RF Modules
101
Parameter Description
4 Digital output, low
5 Digital output, high
Default
0
P3 (DIO13/DOUT)
Sets or displays the DIO13/DOUT configuration (pin 2).
Parameter range
0, 1
Parameter Description
0 Disabled
1 UART DOUT output
Default
1
P4 (DIO14/DIN)
Sets or displays the DIO14/DIN configuration (pin 3).
Parameter range
0, 1
Parameter Description
0 Disabled
1 UART DIN/output
Default
1
PD (Pull Up/Down Direction)
The resistor pull direction bit field (1 = pull-up, 0 = pull-down) for corresponding I/O lines that are set
by the PR command.
Parameter range
0x0 - 0x7FFF
Default
0x0