AT commands Sleep commands
XBee®-PRO 900HP/XSC RF Modules
106
Default
N/A
TP (Board Temperature)
The current module temperature in degrees Celsius in 8-bit two’s compliment format. For example
0x1A = 26 °C, and 0xF6 = -10 °C.
Parameter range
0x00 - 0xFF [read-only]
Default
N/A
%V (Voltage Supply Monitoring)
Displays the supply voltage of the device in mV units.
Parameter range
This is a read-only parameter
Default
N/A
Sleep commands
The following AT commands are sleep commands.
SM (Sleep Mode)
Sets or displays the sleep mode of the device.
Parameter range
0, 1, 4, 5, 7, 8
Parameter Description
0 Normal.
1 Pin sleep. In this mode, the sleep/wake state of the module is controlled by the SLEEP_
REQUEST line.
4
Asynchronous Cyclic Sleep. In this mode, the device periodically sleeps and wakes
based on the SP and ST commands.
5 Asynchronous Cyclic Sleep Pin Wake. When you assert the SLEEP_RQ pin, the device
enters a cyclic sleep mode similar to Asynchronous Cyclic Sleep. When you de-assert
the SLEEP_RQ pin, the device immediately wakes up. The device does not sleep when
you de-assert the SLEEP_RQ pin.
7 Sleep Support
8 Synchronized Cyclic Sleep
To Next Page
Loading...
