Configuration and commands Networking and security commands
XBee®-PRO 900HP/XSC RF Modules
209
Bytes returned
N/A
MD (RF Mode)
Sets or displays the settings that enable the Peer-to-peer or Repeater modes on the device.
Repeater Mode enables longer range via an intermediary device. When MD=3, the module acts as a
“store and forward” repeater. The device repeats any packets not addressed to this node. A Repeater
End Node handles repeated messages, but will not repeat the message over-the-air.
For more information, see Repeater mode.
Binary command
0x32 (50 decimal)
Parameter range
0, 3, 4
Parameter Configuration
0
Peer-to-Peer (transparent operation)
3 Repeater & End Node
4 End Node
Default
0
Bytes returned
1
MY (Source Address)
Sets or displays the Source Address of a device.
For more information, see Addressing.
Binary command
0x2A (42 decimal)
Parameter range
Default
0xFFFF (Disabled - DT (Destination Address) parameter serves as both source and destination
address).
Bytes returned
2
To Next Page
Loading...
